Datavideo SE-200 Pro, Instruction Manual

35

SQ : 001   SR : B2    SN : 01

IN     

     CUT         SP 1 

+0031001

0UT  +0052002      CUT         SP 1

 01.      TITLER            T01             +0033020
                                         
02.      GPI-001                 IN      +0033220
                                         OUT   +0033320
03.     

SQ      EFFECT       PAGE           COUNTER

SQ : 001   SR : B2    SN : 01

IN     

     CUT         SP 1 

+031001

0UT  +052002      CUT         SP 1

 01.      TITLER            T01             +0033020
                                        
02.      
           
03.     

SQ      EFFECT       PAGE           COUNTER

Press the "GPI" key

ii. With the cursor on line 01 in the "EFFECT" column, press the "GPI" key. The 

word "GPI-001" will appear in the "EFFECT" column.

Note: The "IN" and "OUT" counter numbers of the scene will also appear on 
screen in the "COUNTER" column. You can now select the precise point 
within the scene where you want the effect to appear.

iii. Move cursor to the "COUNTER" column. To adjust the counter numbers, 

press the "IN" key (to increase by "seconds"), the "FWD" key (to increase by 
"frames"), the "OUT" key (to decrease by "seconds"), or the "REV" key (to 
decrease by "frames").

Note: If the external device utilizes a SINGLE GPI trigger, you need to adjust 
the "IN" counter number only. If the external device utilizes a DOUBLE GPI 
trigger, you need to adjust both the "IN" and "OUT" counter numbers (to 
establish both the start and end of the effect's duration on screen).

Note: Both of the effect's "IN" and "OUT" counter numbers must be higher 
than the scene's "IN" counter number, but lower than the scene's "OUT" 
counter number. The warning "DURATION ERROR" will be pop up on TV 
screen if counter number of GPI or TITLER trigger point is higher than "OUT" 
point of scene.

NOTE: You can add up to 100 GPI--triggered effects--or combination of 
title effects and GPI--triggered effects-to each scene. 

6.4.5 Creating a Project with synchronous video sources. 

   001:  A.1    01     NO    0030910

SQ    SR     SN   CAL.  DURATION

   002:   A.1   07     YES    0130210

       IN    +0010612            SP 2
       OUT  +0041522             SP 2

       IN    +0353800            SP 1

SP 2

       OUT  +0484010            

003:   A.1   02     NO     0061212

       IN     +0060211  A32    SP  2

       OUT +0121423            

 SP 

3

END:068 TOTAL LENGTH: 0242915

07

The techniques for setting up a Project (rearranging scenes, adding effects, etc.) 
are basically the same for synchronous sources as for non-synchronous sources 
(see section 2, above). With two synchronous sources, however, you can insert 
scenes from the second source into your edited sequence and also create A/B 
Roll effects.

NOTE: it is important here to review the source indicator in the "SR" column on 
the Project Sub-Mode screen: