The SE-200 is available for "A/B ROLL" effects with "SINGLE or DOUBLE" Time Base
Corrector. However, there are some points that should be noticed during
programming the "A/B ROLL" in the edited sequence as following describes:
1. The following A/B Roll effects in the edited sequence are NOT applicable
with the SE-200.
a) A>B Roll --------> B>A Roll
b) B>A Roll --------> A>B Roll
c) A>A Roll
d) B>B Roll
2. The following A/B Roll effects in the edited sequence are applicable with
the SE-200.
a) A>B Roll ---------> B cut to A -------> A>B Roll
b) B>A Roll ---------> A cut to B -------> B>A Roll
c) A>B Roll ---------> B cut to B --------> B>A Roll
d) B>A Roll ---------> A cut to A -------> A>B Roll
Note: The above "CUT" transition effect can be also be a "FADE", "WIPE", or a
"ANIMATION" effects as well.
The above "Roll" transition effects can also be an "A/B DISSOLVE" or "A/B
ANIMATION" effects as well.
3. The edited scene in sequence number "01" of "A" source is not applicable for
a scene with B>A Roll transition effect.
(Please note:You may have a scene in edited sequence number "02" of "A"
source for B>A ROLL effect. But the duration of the edited scene in
sequence number "01" of "A" source will have to be longer than the duration
of the edited scene in "B" source for
B>A ROLL TRANSITION EFFECT.
Otherwise, it will cause a "DURATION ERROR" warning to show on T.V. screen.)
D) Reset all scene information in Project Mode.
Befroe you assemble a new project, Please delete all exist scenes by pressing
the "RESET" key in Project Mode.
38
