f) To insert a title you created in Titler Mode: While your playback source is "IN"
(and the recording VCR is recording), press the "TITLER" key (same as the
"SPEED" key). Enter the two digits that correspond to the title page you want
to appear, and then press the "PLAY" key. The "IN" effect will be activated
after you pressed the "PLAY" key. Press the "PLAY" key again to active the
"OUT" effect. You may continue press the "PLAY" key to recycle playing back
the same page IN and OUT effects. Note: after you insert one title, you can
insert the next title simply by pressing the "NEXT" key. For example, after you
insert title "Page 01" you can insert title "Page 02" by pressing "NEXT" for "IN"
effect of page 02 and continuously press the "PLAY" key for "OUT" effect.
g) To insert a special effect you programmed into the function keys (F1-F30) in
S.E.G. Mode: simply press the function key (F1-F30) that you want.
h) To trigger a GPI effect from a GPI-compatible external source (video mixer,
SEG, etc.): Simply press the "GPI" key. Note: make sure the GPI-compatible
external source is connected properly to the SE-200's GPI jack.
i) To start Manual Edit simply press the "EDIT" key. The recording VCR will be set
up at "Record" + "Pause" status by Editor. If not then please manual control
your recording VCR to enter "Record" + "Pause" mode and then continuously
press the "IN" and "OUT" key and cycle through the "Record" and "Record" +
"Pause" command to record a tape manually.
j) At the end of the Manual Record process (when you have recorded all of
the scenes that you want), stop both the recording VCR and the playback
source. Then rewind the tape in the recording VCR and play it back to view
the results of your edit.
e) If you are editing with two video sources, you can switch sources by pressing
the "A/B SOURCE" key. However, if your sources are non-synchronous, the
video image will "jump" when you switch them. Also, with non-synchronous
sources, the "A/B MIX" key is inactive.
43
6.6 AUDIO PROCESSING
First slide the "T-BAR" control to its uppermost position. Select the VCR A or VCR B
source by pressing the "SOURCE" key. Then gradually change the position of the
"VCR A or VCR B" control until the desired volume level has been obtained.
Repeat this procedure for the "MUSIC" input socket.
To avoid disturbing background noise, rotate the "MIC" in a control clockwise
direction only if you want to add a commentary via the microphone.
The settings of the various controls determine the mixing ratio of the three audio
input signals. The "T-BAR" control controls the mixed audio output signal.
