8
When looking at the rear of the Prompter Hood,
at the top there is a thumb screw which holds
one of two starter rings in place. When the
screw is loosened up the starter ring can be
swapped out by tilting the hood away from you
and lifting the ring out of the bottom retaining rim.
Follow these steps in reverse to fit the hood to a
starter ring. Once the Hood thumb screw is
tightened down the starter ring should be secure
behind the screw tip at the top and the rim edge
at the bottom.
Datavideo supply several stepping rings in the Prompter Kit some are designed to step down from a
77mm diameter and some are designed to step down from 43mm. So these stepping rings
immediately marry with one of the two Hood Starter Rings supplied in the box. If your camera lens
does not immediately marry with either a starter ring or a stepping ring then another ring will need to
be purchased. Please contact your dealer for advice on price and availability of the camera stepping
ring that you require.
