The equipment has been tested and found to comply with the essential requirements and other relevant provisions of Directive
1999/ 5/EC . These limits are designed to provide reasonable protection against harmful interference in residential installations.
It is in compliance with the European Norm for Product standard (CE) to demonstrate the compliance of mobile phones with the basic
restrictions related to human exposure to electromagnetic fields.
This equipment generates uses and can radiate Radio Frequency Energy. If not installed and used in accordance with the user manual,
it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
This UbiSurfer meets government requirements for exposure to radio waves. It is a radio transmitter and a receiver, designed and
manufactured, not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications
Commission (FCC) of the US Government, Industry Canada of the Canadian Government (IC) & The Council of European Union (EU).
These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
The guidelines
thorough
are based on standards that were developed by independent scientific organizations through periodic and
evaluation of
all persons,
scientific studies. The standards include a substantial safety margin designed to assure the safety of
regardless of age and health.
If this equipment is causing harmful interference to radio or television reception, which can be determined by turning the equipment
Off and On, the user is encouraged to try to correct the interference by one or more of the following measures:
with
exposure guidelines while using your UbiSurfer device, use only accessories that
are supplied or approved by the manufacturer.
that are not explicitly approved by DataWind, might violate
and
exposure guidelines and thus void any
applicable to the UbiSurfer device.
to this equipment not explicitly approved by DataWind Ltd. for compliance could void the user's authority to
operate this equipment.
Change the orientation or try to relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer, manufacturer or an experienced and authorized technician for help.
To maintain compliance
FCC, IC and EU, RF
Use of accessories
FCC, IC
EU, RF
warranty
Changes or modifications
Radio Interference Information:
Chapter 5
Important Safety Information
35
