1 DATECS
LINEAPRO 11 INDUSTRIAL
USER MANUAL
UM 07.01.34/v1.1.0 14
Turn off device function
When is pressed this turn off, LineaPro 11 Industrial is going to sleep mode immediately.
Charging Apple device
LineaPro 11 Industrial can charge Apple device, when power source (USB adapter) is attached to USB
connector or LineaPro 11 Industrial is placed on Datecs charging station. Charging Apple device can be
at LOW and HIGH power and depends on the battery charging state and power source.
External Power supply*
When Linea battery is
charging, can be provided
current to Apple device:
When Linea battery is
charged, can be provided
current to Apple device:
500mA
NONE
LOW
1000mA
LOW
HIGH
1500mA
LOW
HIGH
>1500mA
HIGH
HIGH
*Maximum current which can provide the power supply
NONE
–
0A
LOW
–
500mA
HIGH
–
1000mA
LineaPro 11 Industrial can charge Apple device from his own battery. Only is need to be activated
function “Automated Charge”, to be start charging battery level of
LineaPro 11 Industrial must be
above 20%. Charging will stop when Linea battery is below 10%. Charging current to Apple device is
500mA.
Updating Firmware
Firmware of LineaPro 11 Industrial
can be update with newer version. Press “Update Firmware” from
application, first will be shown current firmware version and to which version can be updated, then
press update.
Firmware of LineaPro 11 Industrial barcode
engine can be update with newer version. Press “Update
Barcode Engine Firmware” from application. First will be shown current firmware version and to which
version can be updated, then press update.
