MusiCall user manual
UK
Control
WallUnits
The audio source for a zone can be selected by
pressing ‘channel +’ or ‘channel -‘. The number of
sources and sequence depends on the matrix
configuration. By pressing the ‘c’ and ‘channel -
‘ simultaneously, the local audio input will be selected.
Adjusting the volume for a zone is done by pressing
‘volume +’ or volume -‘. By holding the button, volume
can be increased or decreased. Pressing both + and –
buttons at the same time will mute the zone. Paging to
the zone is always available.
•
When room combining is active slave zones are not able to select the audio
source. Setting the source is only available for the master zone. Slave zones do
have the possibility to adjust volume.
•
On the MAX8.8D en MAX8.16D RDS or meta data can bes end to the wallunit
displays.
Local audio input
Using the local audio input MRA1 or MRA2 an external
audio source like an MP3 player, microphone, laptop or
mixing desk can be added to the system. The MRA1 is
equipped with a balanced audio input on XLR. This way a
microphone can easily be connected. For connecting a
CD player or other RCA sources a conversion cable must
be connected.
Using the Mic/Line switch the input sensitivity can be
adjusted. Set is to line when line level signal is present.
The MRA2 is equipped with both balanced XLR and RCA line level inputs. Each input
can be independently adjusted making a small mix between line and microphone on
the same input.
The Clip/Ovl LED will blink on overloading the input signal.
!
MRC
MRA
