USER’S MANUAL
12
Chapter 3 SAFETY
This heading illustrates potential risks for the operator, maintenance fitter, or any other person
present in the area around the lift, result from incorrect use of the lift.
RISKS FOR EXTRUSION
During up and down operations, personnel leave the said area without following the
rule and instruction.
During up and down operations, no person is admitted to work beneath the movable
parts of the lift, should work in the safe zone. (Picture 6)
RISK OF IMPACT
Before the operator begins up and down movements, make sure that there are no
personnel inside the danger zone. When, due to operational reasons, the lift is stopped
at relatively low elevations (lower than 1.75m above the ground) personnel must be
careful to avoid impact with parts of the machine not marked with special colors.
RISK OF FALLING OFF (PERSONNEL)
During up and down operations, personnel are prohibited from entering the platforms
and the vehicle to avoid falling off.
RISK OF FALLING (VEHICLE)
This hazard may arise in the case of incorrect positioning of the vehicle on the
platforms, overweight of the vehicle, or in the case of vehicles of dimensions that are
not compatible with the capacity of the lift.
When the platform is being tested, the vehicle engine can not be turned on.
There is nothing should be placed on the lift-lowering area and the movable parts of
the lift.
RISK OF SLIPPING (picture 12):
Caused by lubricant contamination that of the floor around the lift. The area beneath
and immediately surrounding the lift and also the platforms must be kept clean.
Remove any oil spills immediately.
RISK OF ELECTRIC SHOCK
Risk of electric shock that in area of insulated and shattered electric equipments.
Do not use jets of water, steam solvents or paint next to the lift, and take special care
to keep such substances clear of the electrical control panel.
Picture 11
（
risk of impact
）
Picture 12
（
risk of slipping
）
