vPad-A1 OPERATORS MANUAL
Each
AutoSetting
will correspond to a single
Test Result
entry. Users can assign a “PASS” or “FAIL”,
depending on the response of the
DUT
, or else bypass that prompt to record a “SKIP”. After generating a
Test Result
for every
AutoSetting
, the A1 will proceed to the next step and repeat as necessary.
5.2.2.1 Running AutoSequences
Following application start-up, vPad-A1 will display the
AutoSequence
dropdown menu on its
Main
screen.
Figure 123
Touching the selection box will display the list of available AutoSequences.
By default, the vPad-A1 will have a number of sample
AutoSequences
pre-installed. Note that these are examples for illustrative purposes only
and they can be freely revised, copied or deleted by the user. New
AutoSequences
can be added as required for new equipment or revised
procedures. There is no limit to the number of AutoSequences that can
be created.
Figure 124
Automation and Test Records/Chapter 5
#
Page 81
Summary of Contents for vPad-A1
