vPad-A1 OPERATORS MANUAL
5.2.2.2 Creating and Editing AutoSequences
After an
AutoSequence
has been selected from the list, its name will be displayed in the menu box
and the
Run
button will be enabled (turned from gray to green). At this point this
AutoSequence
is
available for editing.
There are two main methods to create a new
AutoSequence
: start
from scratch, or use an existing sequence as template. In the
example following, an sample
AutoSequence
“Hypertensive” will
be edited to create a new sequence, and to illustrate the normal
process used to create and/or change the sequence groups.
With the item “Hypertensive” visible in the
AutoSequence
list box,
touch the
button and the
Editor
menu will be
displayed.
The
Editor
menu is divided into three sections:
• the
AutoSettings
selector;
• the
AutoSequence
tree viewer (for working with
Groups
); and
• the
Action Controls
toolbar
Note that the
Action Controls
toolbar can be enlarged:
Figure 130
The larger toolbar may be displayed by pressing either of the
buttons at bottom left and right on the screen.
Figure 128
Figure 129
Automation and Test Records/Chapter 5
#
Page 84
Summary of Contents for vPad-A1
