3: Operation
3-10
RT7000-MSOP
(16) TA/TC/SC Tx ADDR
Allows identification of the address for the station you
are calling. Numbers from 000 to 255 are available.
This number is usually the last three digits of a serial
number.
(17)
ALE submenu
Allows you to configure the ALE system. For informa-
tion about the ALE submenu and how to change system
settings,
refer to "ALE Submenu Described" on page 3-
13.
(18) RECEIVE SET Rx/Tx
Automatically makes the displayed channel an RX and
TX channel. Pressing
ALPHA 8
changes the setting
back to an RX channel.
(19) RF POWER ATU SET
For entering an RF power to use during the tune cycle
for an external automatic antenna tuner. The factory
default setting is 12. Enter a level from 0 to 33.
(20) BITE TEST INITIATED
Automatically starts the RT7000 BITE system.
(21) OPTION 1 TYPE
Allows activation of the Voice Enhancement option if
the 7000VEM is installed in the option card slot. For
more information,
refer to "Activating Voice Enhance-
ment" on page 3-25.
(22) COM 1 BAUD
For configuring the RT7000 COM1 port if you are
working from a computer. Use the arrow buttons to
scroll through and enter the baud rate, data bits, stop
bits, and parity.
(23) COM 2 BAUD
Allows you to configure the RT7000 COM2 port if you
are working from a computer. Use the arrow buttons to
scroll through and enter the baud rate, data bits, stop
bits and parity.
(24) BACKLITE
Automatically toggles between
ON
and
OFF
.
(25) FREQ INC HZ
For determining how much a frequency is increased or
decreased each time you press an arrow button to
change it. The default is set to 100 Hz. Available incre-
ments are 1 Hz to 10 MHz.
