M 6
C
C
K
K
E
E
4a
4d
4d
3
1
4
13
3-1
3-1
4c
3
3.
7
Put the protective caps ( 4d ) on the M8 screw heads on the right and left sides
(see 4.5 / page M8)
Attach the oscillating poles (4/4a) to the hinge pins (4c) with the hexagon head screw (C)
and the washer (D).
he screw should be screwed loosely (not tight)
using the supplied 13mm wrench (see 4.4 page M8 for the final tightening
of the screw).
At this moment, t
Each of the oscillating poles (4/4a) is fitted with two bearing brackets. Mount the bearing
bracket in the middle (4-2) on the corresponding hinge pin (4c) of the dashboard
column (3) as shown in the drawing below. The curved washer (K) supplied in the
hardware bag must be fitted on the hinge pin (4c) before the pole. This washer then sits
between the welded bearing support (3-1) of the dashboard column (3) and the bearing
bracket (4-2) of the oscillating pole.
3.
4
3.
5
3.
6
Use the wrench (13mm) to screw the two hinge pins (4c) in the threaded holes on the right
and left sides of the dashboard support column (3) and tighten them in place.
The 13mm wrench adapts to the 13mm recess on the pin shaft.
4-3
4-3
4-2
4-2
Assembly
Summary of Contents for ergo_lyps
Page 1: ...fitness ...
