Davey Monarch EcoSalt 13, Installation & Operating Instructions Manual

• Page 3 •

IMPORTANT NOTICE:

FACTORS THAT WILL IMPROVE THE PERFORMANCE & LIFE OF YOUR SALT WATER CHLORINATOR

PLEASE READ THIS BEFORE OPERATING YOUR CHLORINATOR

POOL BUILDERS:

 Please cover this information with your customer during the new pool “Hand over 

Session”

Salt Water Chlorinators are a valuable piece of pool sanitising equipment and must be cared for to get the 
best performance and life span from it.

There are 

THREE

 main factors that will damage your chlorinator and reduce the life of the product. Please  

monitor the following factors in accordance with your installation & operating instructions.

  1. MAINTAIN RECOMMENDED SALT LEVELS:

RECOMMENDED OPERATING RANGE: 4500-6000ppm 

NOTE: ABOVE GROUND POOL MODELS ONLY: 2500ppm

•  Run chlorinator at the Salt Levels stated within this document and on the product to ensure 
 

optimum sanitiser output and cell life.

•  Operating this device at low salt levels will damage the cell and reduce its life.
•  The control panel displays a red LED indicator warnings when the salt levels are low.
•  If no action is taken to rectify the salt levels, damage to the cell may result which will not be covered 
 

under warranty.

  2. MONITOR & MAINTAIN YOUR CHLORINATOR CELL:

EcoSalt™  has a “Reverse Polarity” cell.

•  To keep your salt water chlorinator in the best possible condition, regular monitoring of the electrolytic 
 

cell is recommended. The ‘Cell’ is the clear plastic housing containing the removable cell head.

•  During the chlorination process a white powdery Calcium scale may naturally build up on the titanium 
 

plates in the cell.  Monitor the cell to prevent excessive scale build up. Excessive scale build up will cause 

damage to your cell, and dramatically reduce its efficiency and lifespan.

•  Reverse Polarity models have low maintenance cells that minimise scale build up.
•  The control panel displays a red LED indicator warning when the cell requires cleaning.
•  If Calcium scale builds up please clean the cell, following the cleaning instructions provided on page 11.
• 

NEVER

:

 Use concentrated acid to clean your cell.

• 

NEVER

:

 Leave cell in cleaning solution for extended periods of time

• 

NEVER

:

 Use metal implements, scourers or brushes to clean your cell

    3. BALANCED POOL WATER CHEMISTRY:

•  Salt levels MUST be maintained at 4500-6000ppm for optimum performance and lifespan 
 

(NOTE: Above ground pool models: 2500ppm)

•  Calcium Hardness levels 

MUST

 be kept to ideal ranges of 

200-275ppm

 (for Concrete and Tiled Pools) 

and 

100-225ppm

 (for other surfaces) to prevent excessive scale build up and damage to equipment

•  pH levels 

MUST

 be kept to ideal levels to prevent damage to equipment and pool surfaces and to obtain 

optimum sanitiser effectiveness.

•  Total Alkalinity and Stabiliser levels must also be kept in an ideal range. 

Note: Please refer to the RECOMMENDED POOL WATER CHEMISTRY chart on page 13 for more 
information.