Hybrid - Robotic Suction Pool Cleaner
|
Operating Instructions
5
CAUTION
Operating above the MAX. may damage the Hybrid Cleaner.
Table 1: Flow Indicator
Flow Indication
Action
In satisfactory range
Connect the Hybrid Cleaner and begin the cleaning process.
Below
MIN.
To correct the flow do one or more of the following:
• Make sure that the water level of the pool reaches the skimmer.
• Check that the hose is not twisted or bent near the pool connection.
If it is, use the 90° Adaptor.
• Close unused skimmers or main drain. Make sure that the skimmer used
for the Hybrid Cleaner is fully opened.
• Remove trapped air from the hose and Hybrid Cleaner.
• Tighten connections between Hose Sections.
• Backwash the main filter and clean the skimmer and pump basket.
Above
MAX.
• Open unused skimmers partially (if closed).
• If the Hybrid Cleaner is connected to a dedicated suction line, adjust its
control valve on the pool pump.
• If the Hybrid Cleaner is connected to a skimmer, reduce the suction on
the pool pump.
Connect the Hybrid Cleaner
1
Make sure that the pool pump is switched
OFF
.
2
Disconnect the Flow Indicator
(Drawing E)
.
3
Make sure the Float is connected on the hose 40 cm
(1.30 ft) above the Hybrid Cleaner.
4
Make sure that the hose is entirely under the water level
and is filled with water.
5
Hold the Hybrid Cleaner by the handle and put it in the
water. Turn the Hybrid Cleaner upside down to remove
any trapped air.
6
Connect the hose end to the Hybrid Cleaner
(Drawing F).
Make sure that the hose is firmly
connected. Ensure that there is a small space between
the locknut and the pipe.
7
Release the Hybrid Cleaner in the pool.
Restart the pump
min
max
E
3
6
F
