USER’S MANUAL
MA24-02/B
12
5. MAINTENANCE AND CLEANING
The scale does not require any routine maintenance. However, we recommend checking the scale’s accuracy at
regular intervals. The regularity of these checks is dependent on the level of use and the state of the scale.
o
We would recommend using alcohol based wipes or similar when cleaning the scale.
o
Please do not use large amounts of water when cleaning the scale as this will cause damage to the scale’s
electronics, you should also refrain from using corrosive liquids or high pressure washers.
o
Always disconnect the scale from the main power supply before cleaning.
5.1
5.1
5.1
5.1. . . . INSTRUCTIONS FOR CHARGE AND CONNECT
INSTRUCTIONS FOR CHARGE AND CONNECT
INSTRUCTIONS FOR CHARGE AND CONNECT
INSTRUCTIONS FOR CHARGE AND CONNECT
If “Lo” is displayed on the LCD, you should charge scale with AC adaptor.
Locate adaptor plug at the rear of indicator.
Locate adaptor plug at the rear of indicator.
Locate adaptor plug at the rear of indicator.
Locate adaptor plug at the rear of indicator.
CAUTION: Always connect the AC adaptor to the indicator before connecting to the main power supply. Please
disconnect the adaptor from main power supply before indicator.
5.2
5.2
5.2
5.2. . . . INSTRUCTIONS FOR REPLACING BATTERIES
INSTRUCTIONS FOR REPLACING BATTERIES
INSTRUCTIONS FOR REPLACING BATTERIES
INSTRUCTIONS FOR REPLACING BATTERIES
o
Remove the battery cover
o
Take the battery housing out
o
Replace new batteries
o
Make sure batteries are well installed
o
Reinstall the battery housing
1.
Reinstall the battery cover
5.3
5.3
5.3
5.3. . . . ENVIRONMENTAL
ENVIRONMENTAL
ENVIRONMENTAL
ENVIRONMENTAL
All batteries contain toxic compounds; disposal of batteries should be delegated to a competent organization,
complying with the deposit of Poisonous Waste Regulation 1972.
Please do not incinerate batteries.
The optimum operating temperature for the scale is 5ºC to +35ºC; although it will operate at higher and lower
temperatures the scale’s battery life will adversely be affected.
5.
5.
5.
5.4
4
4
4. EQUIPMENT DISPOSAL
. EQUIPMENT DISPOSAL
. EQUIPMENT DISPOSAL
. EQUIPMENT DISPOSAL
All electrical and electronic products should be disposed of separately from the
municipal waste stream via designated collection facilities appointed by the
government or the local authorities.
This crossed-out wheeled bin symbol on the product means the product is covered
by the European Directive 2002/96/EC.
The correct disposal and separate collection of the equipment will help prevent
potential negative consequences for the environment and human health. It is a
precondition for reuse and recycling of used electrical and electronic equipment.
