Model psfm3042
Features
1
Mounts by
A division of David Engineering & Mfg. Inc.
Thank you for purchasing the
PDR
product
To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe
place for future reference.
All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship.
Check the PDR website for details @
www.PDRmounts.com
. We are not liable for improper installation that results in damage
to mounts, adapters or presentation equipment.
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the mounting
unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and airflow.
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the display and the
mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.
Simple 3 piece design
Low profile 1 1/4”
Fits displays with mounting holes not exceeding
639mm left to right and 350mm top to bottom
Recommended for 30” to 42” display
Tilt and lock mounting (patent pending)
125lb load rated
Wall mount to 16” or 24” wood stud location
Lifetime warranty
Made in the USA
Summary of Contents for PDR psfm3042
Page 7: ...this page is blank ...
