DAVINCI GLIDERS / HULA
11
14. Packing your HULA
15. Maintenance and cleaning
Spread the HULA completely out on the ground. Separate the lines to each side. The HULA must be folded
cell to cell to keep the plastic reinforcement at the leading edge lie flat on each other and don’t get bent. Try
to pack your HULA as loosely as the rucksack allows because every fold weakens the fabric.
Avoid packing the glider where it is wet or abrasive conditions(sand, asphalt pavement, concrete)
Cleaning should be carried out with only pure water. If the glider comes in contact with salt
water, clean thoroughly with fresh water. Do not use solvents of any kind, as this may remove
the protective coatings and destroy the fabric.
13. Landing
We recommend landing with trimmers to the normal slow position. Don’t use sharp turns or radical
maneuvers.
When you are 1-2m over the ground, you should face into the wind and standing upright and ready to run.
Finally, you may pull the brakes smoothly for minimizing vertical speed.
Don’t hit the ground by your overtake the glider. If you in windy condition, as soon as you touch the ground
you have to turn around to face the glider and move towards it during full pulling break symmetrically.
