Page 4
EZ-Mount Advanced Station
G
ETTING
S
TARTED
Follow the steps below to install your station. At various stages of this installa-
tion, you will be advised to test the system to ensure proper functioning.
1. Detach and remove the extension tube from the support tube by cutting the two black
cable ties.
2. Attach the anemometer arm to the support tube as shown below. Make sure that the
anemometer is positioned over the white field case and NOT over the black rain collec-
tor cone.
3. Attach the wind cups to the anemometer.
Push the wind cups onto the shaft as far as they will go, then tighten the set
screw. The cups should drop slightly and into the ideal position automati-
cally. Spin the wind cups. If they do not spin freely, loosen the set screw and
lower the cups slightly. Repeat until the wind cups spin freely.
Anemometer Arm
Support Tube
Anemometer
Cable
#12 x 1-1/2"
Screw
Lock
Washer
Hex
Nut
Cable Tie
Anemometer
a. Push cups onto
stainless steel shaft
b. Tighten set screw
with allen wrench
