Preparing the Solar Radiation Shield
Page 5
Installing the Fan Batteries
The fan will begin operating as soon
as you install the batteries. To prevent
discharging the batteries, you should
wait until you are ready to mount the
station outdoors before installing the
batteries.
1.
Insert a NiCad battery in each
compartment, matching the plus
(+) sign on the battery with the
plus (+) sign in the battery com-
partment.
2.
Verify that the fan is blowing air
up and away from the Temp/Hum
sensor.
3.
Insert the O-ring in the groove
around the edge of each battery
compartment.
4.
Attach the battery covers to the
battery compartments using two #4 x 3/8” (9.5 mm) screws each.
Reassembling the Station
1.
Make sure the Temp/Hum sensor cable runs through the provided cable channels
and that the fan unit is seated on the fan plate.
#4 Screws
Battery Cover
1.2 Volt Nicad
Battery
O-Ring
Battery
Compartment
Air
Flow
Installing the Batteries
Fan Unit
Fan Deflector
Motor Connector
Junction Board
Temp/Hum
Sensor Cable
Channel
Fan Plate
Temp/Hum
Sensor
Cable
Sensor Cable Channel in Fan Plate and Fan Deflector
