Page 10
Multi-Purpose Shelter
Mounting On a Pipe
Hold the rear of the shelter and the U-bolt saddles against the pipe and slide
the ends of the U-bolts through the holes in the saddles and shelter so that the
U-bolts wrap around the pipe as shown below. Secure the shelter using a flat
washer and hex nut on each end of the U-bolts. Tighten the hex nuts until the
shelter is firmly attached to the pipe.
✦
If mounting on a pipe with outside diameter between 3/4" and 1-1/4"
(19 mm and 31 mm) use the 1-1/2" U-Bolts and saddles, and the 1/4"
washers and hex nuts.
M
OUNTING
ON
A
S
MALL
P
IPE
✦
If mounting on a pipe with outside diameter between 1-1/2" and 2 3/8"
(38 mm and 60 mm) use the 2-1/4" U-Bolts and saddles, and the 5/16"
washers and hex nuts.
M
OUNTING
ON
A
L
ARGE
P
IPE
