Page 4
Large Surge-Protector Shelter
2. Slide the surge protectors beneath the ground straps.
Fill in starting from the bottom of the shelter. Surge protectors install in
pairs, which should be positioned together as shown below. Position each
surge protector so the hook fits over the ridge provided on the back panel of
the shelter. Make sure the ground plates overlap.
3. Secure each pair of surge protectors in place using a #10 screw, washer, lock washer,
and hex nut as shown below.
Use the #10 x
∫
” (12.5 mm) screws for the top surge protector pairs. Use the
#10 x 1” (25 mm) screws for the lowest surge protector pairs. The extra
screw length allows you to attach the ground wire.
P
OSITIONING
AND
S
ECURING
S
URGE
P
ROTECTORS
4. When all surge protectors are installed, secure the top end of each ground strap to
the shelter using #6 self-tapping screws and # 6 washers.
