8
Mounting the Temp/Hum Station
Mounting the Temp/Hum Station
The Temp/Hum Station can be mounted on a pole or on a vertical surface such
as a wooden post or wall.
Mounting on a Pole
Use a pole having an outside diameter between 1
"
and 1-1/4
"
(25 – 31 mm).
1. Slide the stud ends protruding from the top of the station through the holes
on the mounting bracket.
2. Secure the station to the mounting bracket using a #8 flat washer, #8 split
lock washer and #8 hex nut one each of the stud ends.
Tighten the hex nuts until the station is secure on the mounting bracket.
3. Hold the mounting bracket against the pole. Put two U-bolts around the
pole and insert the ends through the holes in the back of the mounting
bracket.
4. Secure the mounting bracket using 1/4" flat washers and 1/4" hex nuts.
Tighten four set of the washers and hex nuts until the mounting bracket is
firmly mounted on the pole.
Mounting on a Pole
1/4" Flat Washer
1-1/2" U-Bolts
1/4" Hex Nut
