Operation of the Alarm Output Module
Page 9
✦
AOM Cover Label
The label on the cover of the AOM provides spaces in which you may
write the name of the alarm condition connected to each output (A,B, C,
D) and each latch circuit (L1, L2). You may also mark the appropriate
check box to indicate whether the AOM is configured so the outputs are
normally open or closed.
O
PERATION
OF
THE
A
LARM
O
UTPUT
M
ODULE
Operation of the AOM requires the following, each of which is described in a
separate section below:
✦
Programming the AOM (page 9)
✦
Connecting the Outputs (page 11)
✦
Connecting the AOM to the System and Powering the AOM (page 12)
✦
Mounting the AOM (page 14)
Programming the AOM
Programming the AOM involves three main steps: connecting alarm signals to
alarm outputs, selecting between normally-open and normally-closed opera-
tion, and setting the ENABLE switch.
✦
Connecting alarm signals to alarm outputs
To connect an alarm to an alarm output, insert the desired jumper wire
from J5 into the appropriate pin jack at J3. Use the table on page 9 to
determine pin assignments. Once you make your alarm output pin
assignments, you may find it useful to write them in the left-hand col-
umn of the table on page 9. Write the letter of the alarm output next to
the number of the pin to which that output is assigned.
C
ONNECTING
A
LARMS
TO
A
LARM
O
UTPUTS
