Using the Console
Page 20
Vantage Pro Console Manual
Screen 1: ActiveTransmitters
Screen 1 displays the active transmitters located in your area. The ticker will
display the message “Receiving from...” and the active transmitter IDs will be
illuminated. In addition, an “X” should intermittently appear in the lower
right-hand corner o f the screen. The rest of the display screen will be blank. If
you have a cabled station, this screen will display “Receiving from station No.
1.”
Note:
Transmitters must be switched on for the console to recognize them. Refer to your ISS or other trans-
mitter manual to see how to switch them on.
This screen requires no input; it simply shows you what transmitters the con-
sole can receive. Press and release the “DONE” key to move to screen 2.
Each wireless console/receiver may receive signals from up to eight different
transmitters
; however, only certain combinations of transmitters are possible.
Table 1 below lists the maximum numbers of transmitter types each console/
receiver can handle:
Screen 2: Selecting transmitters
Use setup screen 2 to tell the console/receiver which transmitter IDs to listen
to, and what kind of station each transmitter represents.
Table 1: Maximum Transmitters per wireless Console/Receiver
Transmitter Type
Maximum per
Console (8
total)
Integrated Sensor Suite (ISS)
1
Anemometer Transmitter Kit
1
Leaf Wetness/Temperature Station
1
Soil Moisture/Temperature Station
1
Temperature Station
8
Temperature/Humidity Station
8
STATION NO.1 4
Setup Screen 1: Transmitters. This screen shows the Con-
sole receiving transmssions from transmitter IDs 1 and 4.
Summary of Contents for and Vantage Pro
