Page 1
I
NTRODUCTION
The following instructions explain how to complete a DriveR-
ight VSS (Vehicle Speed Sensor) installation. VSS installation
is only possible on the DriveRight Trip 500AL.
C
OMPONENTS
The DriveRight Trip 500AL (VSS Input) should come with all
of the materials shown below. Please make sure you have all
listed components before proceeding with the installation.
DriveRight Display
Mounting Bracket
Battery
(CR123 3V Lithium)
Visor Clip
Harness Cable
Red +12V Wire
with Fuseholder (22 AWG)
Fuses (2)
(3AG 1-1/4 x 1/4",
.25A, Slo-Blo)
Black Ground Wire
(22AWG)
White VSS Wire
(22AWG)
Split Flexible Tubing
Coiled Cable Extension
Right Angle Adapter Bracket
Tie Wraps (12)
Butt Splices (5)
(26-22AWG or 24-20AWG)
In-Line Splice
Spade Terminal Sets:
T-Tap Disconnects:
Insulated Male Disconnects
(18-22AWG)
#8-10 Studs
(3.5 - 5 mm)
Velcro® Tape (4 pair)
Double-Sided Foam Tape (4 strips)
#6 x 1/2" Pan Head Self-Tapping Screws (3)
#6 x 1/2" Flat Head Self-Tapping Screws (3)
6-32 x 1/2" Flat Head Machine Screws (3)
6-32 Nuts (3)
#6 Flat Washers (6)
#6 Split Lock Washers (6)
NOTE: Small hardware includes spares not required for installation.
1/4" Studs
(6 mm)
Blue
(14-16AWG)
Red
(18-22AWG)
