-6-
-7-
Functions of the Product
Your hood is compatible for use with our without chimney.
Usage with chimney
The product should be connected to a chimney that will direct the air out during usage with
chimney. In order to achieve best performance, pay attention that the duct system follows the
shortest way for connection to the chimney. Your product is produced as it will be appropriate for
usage with chimney.
Attention!!!
Outlet of the product should not be connected to air canals that have other smoke as well.
Active Carbon Filter
To provide air recirculation where product's chimney air outlet cannot be connected to exterior, it is
necessary to use active carbon filter with your product. You may purchase this accessory from
authorized sellers and after sales services.
Carbon Filter Usage
Your product is compatible with two types of carbon filters.
You may see following information on how to use carbon filters.
Before installing or replacing carbon filter, first you should cut your product's power off.Carbon
filters should be replaced with a new one each 3-5 months because it is used at kitchens that does
not have chimney outlet.Carbon filter should never be washed.Grease filters should be installed on
the product even when carbon filter is not in use. Do not use your product without grease filter.
ATTACHING THE PLASTIC CHÝMNEY:
Attache the plastic chimney wich is in your cooker hood.
(Picture 3)
Picture
3
Picture
4
Picture 5
Figure 4
Replacing the Lamps
Cut off the connection of the cooker hood with electricity.
Take off the aluminum cassette filter. Take off the failed
lamp and replace it with a new one that is of the same
rating. (Please wait for the lamps to cool as they might hurt
your hand.)
Replacing 50W Halogen Lamp
In order to change halogen lamps, take the lamp
downwards pushing back of lamp holder downwards and
then turning it a little bit anti-clockwise take it off
downwards.
Figure 5
Figure 5
Provide an aluminum pipe and connect one end of this
pipe to the plastic chimney of the device and the other end
to the kitchen chimney. Check that these two connections
are in a frequency not causing maximal cycle in the hood.
(
Picture 4)
Flections and bends at the alumi
nium pipe reduce the
air absorbtion power, because of that use less flections
and bends as possible.
Correct
False
Replacing Carbon Filter
It is necessary to install 2 carbon filters to your product.
To place the carbon filter, place your filter on connection
channels on motor and turn it clockwise.
In order to remove filter, turn it anti-clockwise. Figure 6
Figure 6
