DV-201DM for H.323 & SIP
[Example]
DV_GW>
dir
©
SYstem/ COnfig/ Ftp_client/ Test/ Netutil/
STatistics/ Vocfile/ Debug/ Memory/
CD
"cd" is a command to change the working directory. A directory you want to move
can be given an direct path starting from a route directory or given a relative path
based on the current directory. It is possible to change directory by typing the
name of directory without “cd” command or by typing capitalized character of name
of destination directory. Same results are displayed in case of typing “cd system”
or in case of typing “system” or in case of typing “s” (minimized letter of destination
directory “system”). If only “cd” without any character is typed, they can see root
directory. The following example is an after executing “cd” command on root
directory.
[Example]
DV_GW>
cd system
©
DV_GW/SYSTEM>
2.3.2 IP Configuration
1. Command
directory
DV_GW/CONFIG/IP>
2. Command
function
These commands are used for setting NAT Mode, IP address, subnet mask,
gateway, Ethernet address .
3. Available
commands
Commands
Description
SHOW
Show IP parameters
CHANGE
Change IP parameters
Ether set
Set Ethernet address
2 - 36
Summary of Contents for DV-201DM
