DIVINSUP-2-1X5A Manual
Reasonable prices, priceless reasoning.
3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9206 •
Installation
It is recommended that assistance be available to safely install equipment in
equipment racks.
1
.Install chassis in equipment rack (equipment rack sold separately) by supporting the bottom and rear of
DIVINSUP-2-1X5A
at the desired elevation in rack.
2
.Line up the side holes of chassis with the tapped equipment rack holes.
3
.Insert the provided screws through the mounting holes at the extreme left and right of faceplate and thread into the tapped equipment rack holes.
4
. Fasten the bottom screws first, then fasten top screws.(tighten securely).
5
.Connect a cable from the satellite vertical polarity low noise block converter (LNB) to the vertical input connector of the
DIVINSUP-2-1X5A
.
6
.Connect a cable from the satellite horizontal polarity low noise block converter (LNB) to the horizontal input connector of the
DIVINSUP-2-1X5A
.
7
.Connect a cable from the output connector the
DIVINSUP-2-1X5A
to the input of a satellite receiver
8
.Plug the wall adaptor plug into the jack located in the back of the unit.
9
.Plug the adaptor into a 120Vac, 60Hz wall receptacle.
