Connecting
(stage 3)
Step 1 - Connect Faucet to Tank
Connect the pipe of marked red label on the faucet by 1/4" (6.35 mm) PE tube to the rear pipe at the top corner of
tank with the quick-connect fitting supplied with the appliance. (Do not use the quick-connect fitting with filter and
cap.)
Push line straight into quick-connect fitting as far as possible for both connections.
Install the compression tube assy. on the outlet pipe of tank.
Use pliers to open clamp and thread the silicon tube through clamp then push fully onto compression tube assy.
Mounted on center outlet pipe on top of tank. The clamp should create a secure connection when properly installed.
Be sure the silicon tube is not twisted or kinked. Hose may be shortened if necessary.
NOTE:
DO NOT lengthen the silicon tube
–
dispenser
performance will be impaired and warranty will be void.
Quick-connect
fitting
Compression
tube assy.
16
Make sure the tank
outlet silicon tube has
no loops or low areas.
Quick-connect
fitting with filter
and cap
