Step 2.0 Connect Cold Water Supply (f
or water supply without filter or chiller)
Check filter in Quick-Connect Fitting with Filter and Cap .
The cone-shaped screen filter comes seated inside the quick-connect fitting as shown in the illustration below, with
the narrow end protruding through the cap which is also attached to the fitting. (The open or wide end of the screen is
inserted into the fitting.) However, the filter may become dislodged in the shipping process.
Check to see that it is seated correctly within the fitting. If the cap is still in place, pop cap off by slipping a screwdriver
into the notch and lift off. Gently pull on the screen. If it comes loose, push in with a light jiggling or wiggling motion
until it snaps into place. If installed property, a gentle pull should not dislodge it.
Cold water is supplied to the tank through the faucet.
Connect the cold water line to the faucet using the 1/4"
(6.35 mm) supply line and the quick-connect fitting that
contains a cone shaped screen filter (supplied with the
tank.) The cap end of the fitting connects to the faucet
line.
It is suggested that a shut-off valve be installed
between this connection and the cold water supply line.
quick-connect fitting
with Filter and cap
Filter and cap side
points toward faucet.
Shut-off valve
17
