DAY Useful Everyday schou 72112 Instruction Manual Download

Page: 10 / 26

Warning: To prevent possible hearing

damage, do not listen at high volume

levels for long periods.

to automatically search for stations.
After about one minute, the speaker
will automatically tune to the ﬁrst
channel.
Then double press the (2)pause
button to stop the automatic channel
search and to listen to your favorite
channel. Press
(1)volume - for the previous channel,
and press (3) for the next
channel.
Press (4)Mode again to exit FM mode.
In standby mode, the speaker will
automatically shut down with a voice
reminder that sounds after 10 min-
utes of no interaction.

8. AUX: Use a 3.5 mm audio cable (ex-

cluded) to connect the speaker to an
external sound source.

9. Battery charge: Built-in overcharge

and short-circuit protection.
Electric charging current: DC 5V 500
mAh.
Please use a suitable adapter with
input voltage: 5V/2A or 5V/1A. Oth-
erwise, the speaker may be damaged
due to high voltage or the current
might be too low to fully charge.
Charging indicator: Red light; the
light will turn off when charging is
ﬁnished.
It is recommended to fully charge the
device before ﬁrst use.
It is not recommended to play music
while charging. It might result in
excessive load on the battery, which
affects the battery life.

NOTICE

The product has anti-interference,
but very strong and high-frequency
microwave and magnetic ﬁelds will still
interfere with the product. Please do
not use it in such conditions.

Bluetooth is a two-way transmission,
different user terminals have different
transmission ranges. Please use stand-
ard Bluetooth devices.

The modes are isolated from each oth-
er, it can not work in two modes at the
same time.

If the speaker is not used for a long
time, please recharge it once a month
to maintain the battery life.

SECURITY WARNING

If the speaker suddenly starts to smoke
or other unusual phenomena occur
during charging, please unplug the
power cord quickly to avoid accidents.

If the speaker is hit by rain or damp-
ness, please put the speaker in a venti-
lated cool place to dry, and avoid drying
it at high temperatures. The equipment
will easily burn or the components
inside might break.

Do not place the speaker in environ-
ments with a high temperature such as
ﬁres, near a heater, etc.

If the speaker is not used for a long
time, it should be placed in a cool
and dry environment. Please unplug
the power supply. Charge once every
month.

TECHNICAL DATA

Bluetooth version: 5.0
Output power: 5 W × 4
Loudspeaker size: Ø52 mm
System frequency: 80 Hz-16 KHz
Signal-to-noise ratio: 80 dB
Sensitivity (induction voltage): 40 mV
Product size: 38×9×8 cm
Built-in battery: 2400 mAh Li-ion
Charging voltage: DC 5V 500 mAh

(via Micro USB)

Play time: 6 hours (at 50% volume level)
Full charge time: 3,5-4 hours
Sound sources: Bluetooth, FM radio,
MP3
from TF card, and AUX port
RF Output Power -0,23 dB e.i.r.p
Frequency range: 2,402-2,480 GHz.

OVERVIEW

1. Prev./ volume-
2. Play/Pause/FM scanning
3. Next/
4. Mode button
5. Microphone
6. TF card
7. AUX
8. DC 5V charging port
9. ON/OFF

BASIC OPERATION INSTRUCTIONS

1. Power on/off: Slide the button to ON.

The product turns on and automati-
cally enters Bluetooth mode. Slide the
button to OFF. The power turns off.

2. Bluetooth

Re-link: When the power is on, the
product will try to re-connect to a
previously linked device, if it can-
not, it turns back to auto search after
about 10 sec.
Matching: Turn your device on,
search for Bluetooth devices and tap
to “match” with “DAY speaker”.
Bluetooth is a peer-to-peer connec-
tion, meaning only one device can be
connected at a time. When connect-
ed, the match cannot be deleted,
please disconnect ﬁrst.

3. Play music: Press (2), to play music

and press it again to pause.

4. Adjust Volume: Long press button (1)

or button (3) for volume down and up.

5. Next/Prev.: Shortly press button (1)

or (3).

6. TF card: Plug the TF card, with MP3

ﬁles, into the slot in the correct
direction. The device will automati-
cally switch to TF card mode and play
music from your card.

7. FM radio: Plug in an AUX cable

(excluded) or a USB. Note: An AUX
or a USB cable should be inserted as
an antenna in FM mode. Turn on the
power, press (4)Mode to enter the
FM mode, and double press (2)pause

Speaker

INTRODUCTION

To get the most out of your new wireless speaker, please read through these instructions
before use. Please also save the instructions in case you need to refer to them at a later date.