8
SET-UP AND ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts in a cleared area and remove the
packing materials from the spa shell; do not dis-
pose of the packing materials until assembly is
completed and the spa is in operation.
¥ Assembly requires two people.
¥ During assembly, make sure that all parts are ori-
ented as shown in the drawings.
¥ Read each assembly step before you begin.
¥
Tighten all parts as you assemble them, unless
instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING
TOOLS (not included):
¥ One (1) phillips screwdriver
¥ You may also need some soap or wax.
1.
Before beginning assembly, be sure that you
have read and understand the information on
the previous two pages.
Remove the four cover screws from the access
cover. Remove the access cover from the Spa Unit
(15) by sliding the access cover down and pulling
the bottom of access cover away from the Spa Unit.
Be careful not to damage the spa shell.
Remove the Power Cord with the GFCI (38) from
inside the Spa Unit (15).
2.
Locate and check the position of the cut-off valves.
Occasionally the valves will be closed at the factory
during manufacturing. The cut-off valves must be
open for proper spa operation. To open the valves,
hold one of the handles and turn the handle until
you can pull it out to the open position. Open the
other valve in the same manner.
WARNING: THE
MOTOR WILL BE DAMAGED IF IT IS OPERATED
WITH THE CUT-OFF VALVES CLOSED.
Close the valve knob on the drain hose. Thread the
cap onto the drain hose. Thread the drain plug into
the Pump Motor (13). Tighten the pump fittings.
1
Access
Cover
Access Cover
Screws
Spa
Shell
15
38
2
Cut-off Valve
Pump
Fittings
Cut-off
Valve
Drain Hose
Valve
Knob
Cap
13
Drain
Plug
