10
When preparing fuel mixture, mix only the amount needed for the job you are to do.
1. Move the stop switch to ‘START’ position.
2. Give a gentle push on the primer pump repeatedly (7-10 times) until fuel comes into
the primer pump.
3. Cold starts: Pull lever up to choke position.
4. Pull starter handle until engine false fires.
5. Push choke lever inwards (excessive cranking with choke lever will cause flooding
engine making it difficult to start).
6. Pull starter handle until engine starts.
7. Allow engine to warm up for a few minutes before using.
Starting Cold Engine
Ÿ
Check and confirm that the fuel tank has sufficient fuel for the work or add fresh
fill of 2 stroke fuel as above.
Ÿ
It is recommended that the 2 stroke is mixed in a separate container before filling
into the fuel tank.
WARNING
WARNING
Store fuel only in a clean, safe, approved container. Check and
follow local rules on type and location of storage container.
WARNING
WARNING
Two-stroke fuel may separate hence shake fuel container
thoroughly before each use.
WARNING
WARNING
Stored fuel also ages. Do not mix more fuel than you expect to
use within a period, say a month.
WARNING
WARNING
Do not use fuel that has been stored longer than two months.
Fuel mixture stored longer than this will cause hard starting
and poor performance. If fuel mix has been stored longer than
this time, it should be removed and lled with fresh mixture.
Safety Lever
Throttle Level
Stop Switch
STOP
START