21
WARNING
To quickly detach the pole saw from the shoulder strap ,pull the
quick-release latch tab upward.
Controls
1. Throttle trigger lockout
2. Throttle lever
3. Slide switch
1
3
4
Starting
Press down the trigger lockout lever and squeeze the throttle lever and hold them in that
position. Move the slide switch to START and hold it there. Now release the throttle lever,
slide switch and trigger lockout in order. This is the starting throttle position. Set the choke
knob: if the engine is cold for warm start – also use this position if the engine has been
running but is still cold. Press the fuel pump bulb at least five times – even if the bulb is
already filled with fuel.
Starting Method 1:
Ÿ
Remove the blade scabbard. Check that the chain is not touching the ground or any
other obstacles.
Ÿ
Place the unit on the ground: It must rest securely on the engine support and the hook.
If necessary, rest the hook on a raised support (e.g. a branch, mound or something.
Ÿ
Make sure there is safe and secure footing.
Ÿ
Hold the unit with the left hand on the fan housing and press down firmly – the
operators thumb should be under the fan housing.
WARNING
Check that nobody is standing within the working range of the
pruner.
WARNING
Do not stand or kneel on the drive tube. This will bend the drive
tube and may result in permanent damage.
Starting Method 2:
Ÿ
Remove the chain guard. Position the shaft on a branch so that it is held by the hook.
Ÿ
Hold the unit firmly with the left hand on the fan housing – the thumb should be under
the fan housing.
