4
WARNING
Ensure no water leakage onto the pump motor or its
electrical connections during installation, venting or
operation as this may cause electrical shock.
WARNING
Any action that doesn’t comply with safety warning sign
may cause personal injury, pump damage and losses in
property. Users must also comply with the local safety
regulations.
WARNING
Do not install the pump in moist places.
WARNING
For easy maintenance, it is recommended to install
separate valve at the inlet and outlet of the pump. These
should be closed when the pump is not in use for a long
time.
WARNING
Dry running will void warranty.
WARNING
The pump should be stored in a cool, dry and well
ventilated place.
3. INSTALLATION
3.1 Electrical Connection
Ÿ
If the electrical connection block is not in a convenient position when the
circulator pump is delivered, the motor head may be rotated prior to fitting.
Ÿ
To achieve this, release the screws on the pump casing and rotate the
motor head to its new position.
Ÿ
Take care not to remove or damage the ‘O’ ring seal between motor head
and pump casing.
Ÿ
Tighten the fixing screws in a diagonal pattern in stages to final torque of
25kg cm.
Ÿ
Check that the turns freely by loosening the manual Restart Knob until it
engages in the motor shaft. The motor should then be free to turn with the
finger tips.
