Assembly and Adjustment
Handlebars
The area which you will be working on is just under the center of the handlebars.
You can find the nut that attaches the core pole of the bike to the wheel just under
the dash of the bike. There should be a plastic cover (clearly visible) that is about 2
inches long and 1 inch wide. Please remove this plastic cover to access the nut to the
core pole.
1.
Loosen the nut on the core pole and adjust the handlebars to the desired
position. Please do not exceed the safety lines carved on the pole.
Keep the distance of the core pole of handlebars, the joint nut holding the
handlebars, and the front forks of on the wheels aligned.
Tighten the nut on the core pole.
Keep the distance of core pole of handlebars and nut less than 18N.m.
Brakes
2. Adjust the performance of the front brakes by turning the screw. Make sure the
distance between the brake strap and the wheel rim less than 3mm apart. Keep the
surface away from the side of rim or else the wheel cannot brake properly. When
the drum brakes have been reduced by 1/3, please change for a new one.
3. Adjust the rear brakes by turning the screw. Tighten the screw enough so that the
wheel does not rotate when the bike brakes. Loosen the screw if the braking system
seems strained.
Front Wheels
Summary of Contents for Ecostar
Page 5: ......
