4. Loosening the nuts on both sides of the front axle will allow you to remove the
front wheel. When replacing the front wheel, fix the wheel on the axle appropriately
and tighten the nuts accordingly. The two bolts should be secured with the same
distance tightened onto the fork to keep the wheel in the central alignment.
Chain
5. To adjust the tightness of the chain, loosen the two nuts holding the rear wheel to
the axle. Loosen enough so that you can slide the wheel back to tighten/loosen the
chain. The tightness off the chain can be measure by pressing a finger on the center
of the chain down. The distance that the chain should move is 15mm.
Rear Wheel
If there is any issue with the rear wheel, please refrain from doing any work on it.
The rear wheel houses the motor hub of the e-bike and any damage to it can
compromise the functionality of the bike. Please bring the bike into one of our shops
for repairs. Taking it to anywhere else will void all warranty of the e-bike and you will
take full responsibility for all damages to the bike.
Safety and Maintenance
The bicycle must be maintained properly in order for it to provide you with utmost
quality and overall safety.
1.
Check to see whether the rear wheel (motor) makes loud/weird/unusual sounds
upon turning. If yes, please take it to our service department to prevent further
damage to the motor.
2.
Check to make sure all external and internal components are connected and
tightened. This includes the wiring of the controller, the tightness of bolts, and
so forth.
3.
Check the braking system: including lights and reaction time of the brakes.
4.
Try to keep your bicycle as clean as possible after each ride.
5.
Apply grease to the front and back axles periodically for better functionality. Also
keep the brake wires well lubricated.
Summary of Contents for Ecostar
Page 5: ......
