The Gatto Electric Bicycle User’s Guide
TPS Training Bulletin
Page 13
.
Charging your E-Bike
Charging your e-bike is a simple process. You require the following:
•
The charger that came with your e-bike
•
A 110V household electrical outlet
Charger Warning
Only use the charger that was supplied with your e-bike. Using a
charger which does not have specifications identical to those which
originally came with the e-bike could irreparably damage your e-bike’s
battery and electrical systems, and may cause injury.
To charge your e-bike, follow these steps:
1.
Turn off the e-bike and remove the key from the “ignition”.
2.
Plug the female end of the charger cable into the charging slot on the e-bike. This is
found on the outside casing of the e-bike, in front of and just underneath the seat.
3.
Plug the male end of the charger power cable into your wall socket. This should be a
110v household electricity supply. You can also use a portable generator, if
necessary, but make sure it provides 110V current.
4.
Allow the e-bike to charge for the appropriate amount of time (3-8 hours).
5.
Disconnect the charger when the LED light on the charger is green. The battery has
been fully charged.
Note
If your charger’s LED status light does not change from red to green over an extended
period of time, for perhaps more than 14 hours, and the battery is very hot, the battery
or charger may need replacing. Stop charging and bring both to your Daymak dealer
immediately. Do not charge the battery.
