13
Charging your Atv
Charging your atv is a simple process. You require the following:
•
The charger that came with your atv.
•
A 110V household electrical outlet.
Charger Warning
Only use the chargers that were supplied with your atv. Using chargers that do not have
specifications identical to those which came with the atv could irreparably damage your
atv’s battery and electrical systems, and may cause injury.
To charge your atv, follow these steps:
1. Turn off the atv and remove the key from the “ignition.”
2. Plug the female end of the charger cable into the charging slot on the atv.
3. Plug the male end of the charger power cable into your wall socket. This should be
a110v household electricity supply. You can also use a portable generator, if necessary,
but make sure it provides 110V current.
4. Allow the atv’s battery to charge for the appropriate amount of time
(8-10 hours).
5. Disconnect the charger when the LED light on the charger is green. The batteries
have been fully charged.
If your charger’s LED status light does not change from red to green over an extended
period of time, for perhaps more than 14 hours, and the battery is very hot, the battery
or charger may need replacing. Stop charging and bring both to your Daymak dealer
immediately. Do not charge the battery.
Summary of Contents for SASQUATCH JR
Page 1: ...sasquatch jr User Manual...
Page 27: ...27...
