Genesis MP
Chapter 3 – Connecting Additional Peripherals
◆
39
Adding Memory
Adding memory to your Genesis MP was designed to be extremely easy.
Just remove the side panel, and you will be able to install your Dual Inline Memory
Modules (DIMMs) into the DIMM sockets. Genesis MP supports DIMM sizes of 8, 16, 32,
64 or 128 MB. The six slot Genesis MP has 12 DIMM sockets and supports up to 1,536
MB of RAM, while the three slot model has 8 DIMM sockets and support up to 1,024 MB.
DIMMs should be 64-bit wide, 168-pin fast-paged mode with 70ns or faster access times.
Performance tip: Although DIMMs can be added one at a time to your system, you can
increase your performance by only installing like pairs of memory in your machine. By
installing memory in pairs into the correct locations, you can enable memory interleav-
ing, which effectively provides 128-bit memory access from 64-bit DIMMs.
Steps for installing Memory
1. Open Genesis MP (loosen the side door panel) by following the easy instructions
listed previously in this chapter. Remember to turn everything off.
2. Put on your anti-static wrist strap.
3. Locate the DIMM sockets on the motherboard
3-Slot Genesis MP Motherboard
6-Slot Genesis MP Motherboard
4. Choose the DIMM sockets you wish to use for the installation.
Bank 4
Bank 3
Bank 2
Bank 1
Bank 4
Bank 3
Bank 2
Bank 1
Bank 6
Bank 5
Bank 4
Bank 3
Bank 2
Bank 1
Bank 6
Bank 5
Bank 4
Bank 3
Bank 2
Bank 1