11
4.3.2. Set aI, aE, d Value
⚫
Set aI value: Pull gauge out, first to touch position of FI to measure aI value, press
or
to input
aI value.
⚫
Set aE value :Then touch position of FE to measure aE value, press
or
to input aE value.
⚫
Set d value: Then press
and
to input d value. = Inside Diameter of rim
Fig. 9
4.3.3. Put down the guard and press
to perform a measuring spin. 4.3.1. 12 o’clock position to add weight
Set SLC as OFF according to 8.1
Anticlockwise moving wheel slowly, until the right LED lit up full, add weight on 12 o’clock position (Fig.10)
Fig. 10
Anticlockwise moving wheel slowly, until the left LED lit up full, add weight on 12 o’clock position (Fig.11)
Fig. 11
After finishing mounting the counterweights, put down the guard and press
,
to perform balancing spin again, if