21
Auto EQ Menu
A. Graph – Once the measurement process has been completed, this graph will display the response as mea-
sured (grey line) and the simulated response with EQ applied (blue line). The locations of each EQ band
can also be seen labeled with a colored number and colored dashed lines.
1. Dropdown Menu – Select your desired preset or preset slot from this dropdown menu. If loading or
saving a preset, this selection will be the slot saved to or loaded from.
B. Volume Slider – This is the same master volume slider that can be found in the Volume/Phase/Input
menu. It has been duplicated here to allow the volume to be quickly reduced before taking measure-
ments.
C. EQ Results – The calculated results of the auto EQ process can be found here. Each number represents
a band of EQ, and the frequency, gain and Q of each band can be seen below the colored number of the
band. These results can also be found in the PEQ menu, where they can be further customized.
D. Buttons for auto EQ
1. Remove EQ – This button will remove the results of a previous auto EQ from this page. It will also
disable but not reset the values of all bands in the “5 Band PEQ” in the PEQ menu.
2. Restart – This button will restart the auto EQ process. After a moment, the green button will change
to “Start Position 1”, no matter how far along in the process you are.
3. Start Position X – Press this button to start measurements at each position. Once the button is
pressed for the first time, all values from the 5 Band PEQ will be reset.