6
Rear Panel
A. Mic In: Microphone input for auto room EQ calibration (Note: Use the microphone that came with the device. The
software is calibrated for the included mic, and results WILL VARY if a different mic is used.)
B. LAN: Connect your APA1200DSP to a network (via a router or network switch) with a standard ethernet patch
cable to enable remote control of all device settings via any web browser of a device on the same network.
C. DC12V Trigger: 12VDC input to turn on/off the APA1200DSP with an external control device.
D. Power On Setting: There are 3 possible modes for this setting.
1. ON: The device will remain on at all times as long as the unit is connected to power and the power switch on
the rear of the device is switched on.
2. Auto: If the amplifier does not detect an analog input signal greater than the threshold selected in the power
saving menu, it will automatically enter standby. If you want to wake up in Auto mode, you can input a music
signal over the selected threshold or select the ON mode. NOTE: This mode should not be used if the digital
coax connection is used, as the digital coax connection cannot trigger the device out of standby.
3. 12V Trigger: Will confirm that there is no audio signal and DC 12V before entering standby. If you want to
wake up under 12V Trigger, you can input DC12V or select ON.
E. Digital Input: Coax Digital Audio Input. (SPDIF)
F. Input: Analog RCA x 2 or XLR x 2.
G. Input Attenuation Switch: Adjust between -10dbV (900mV max input before clipping)
and -4dBV (1.8Vrms before clipping)
H. Preamplifier Output: Analog RCA x 2 or XLR x 2.
I. Speaker Output: Binding post x 4.
2 Ohm Minimum for Stereo Configuration
4 Ohm Minimum for Bridged Configuration
J. Power Switch: Turn On/Off the amplifier.
K. Power: Connect the included power cord (IEC 60320-C13)
CAUTION
RISK OF ELECTRONIC SHOCK
DO NOT OPEN
AVIS:RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
