7
CONNECTIONS
The SBA302-BT is a simple plug and play design, and requires just a few connections to be made. Take care when making
connection or especially disconnecting. Damaged cables or connectors can cause issues that may be difficult to diagnose.
1) Front Panel – The 6" 7-pin cable will come pre-attached to the front panel (houses the status LEDs and IR target). The
other end needs connected to the 7-pin header on the amplifier board.
2) Control Panel – The 23" 6-pin cable for the control panel will come in the pack of wires that you also use for your
speaker connections. Plug one end of the cable into the control panel, and the other end into the 6-pin header on the
amplifier board.
3) Right Speaker – Using one of the 2-pin cables that come with the amplifier kit (22" red/black wire), connect your
loudspeaker or crossover circuit for the right channel into the header on the amplifier board.
4) Left Speaker – Using one of the 2-pin cables that come with the amplifier kit (28" blue/black wire), connect your
loudspeaker or crossover circuit for the left channel into the header on the amplifier board.
SPECIFICATIONS
SBA302-BT User Manual.indd 7
SBA302-BT User Manual.indd 7
10/18/21 1:40 PM
10/18/21 1:40 PM
