Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005
42
Armature Inspection
a) Inspect the armature surface for uneven wear or
damages or burn;
When where are metal fines attached to the gap of the
armature surface, use a cleaning cloth to remove
them.
b) Measure the conducting condition of the armature coil
according to the picture; it should be conductive.
c) Measure the conducting condition between the
armature coil and armature according to the right picture; it should be non-conductive;
If not, it should be replaced.
Carbon Brush Inspection
a) Inspect the insulating condition between the connecting
wire terminal and starter motor case; it should be non-
conductive.
b) Inspect the conducting condition between the connecting
wire terminal and the carbon brush, and it should be
conductive.
c) Measure the length of the carbon brush;
Replace it if the length value exceeds the service limit.
d) Measure the insulating condition of the carbon brush
bracket, it should be non-conductive;
If not, it should be replaced.
Please don’t use the sandpaper to grind the
armature, or wash it in any solvent that can
dissolve or damage its insulation.
Summary of Contents for Raider-Classic 150
Page 1: ......
