Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005
55
b) Inspect if there is any abrasion or damage on the driven plate;
Measure the outer diameter of the driven plate pulley hub.
c) Inspect if there is any abrasion or damage on the movable driven
plate;
Measure the inner diameter of the movable driven plate.
d) Inspect if the groove of the guide pin is worn.
Replacement of Driven Plate Bearing
a) Remove the needle bearing from the driven plate.
b) Remove the circlip from the driven plate.
c) Drive the ball bearing out.
d) y some grease on the new ball bearing.
e) Drive the ball bearing into the driven plate with its front face
upwards.
e) Assemble the circlip.
g) Apply grease evenly on the inner wall of the driven plate.
Service limit
33.94mm
Service limit 34.06mm
If the driven plate needle bearing and ball bearing are loose, damaged, or have
some unusual sound, they should be replaced.
The removed bearing can’t be reused.
The removed bearing can’t be reused
Use the prescribed grease.
Summary of Contents for Raider-Classic 150
Page 1: ......
