Low Impedance Stability
For added low frequency performance the Multi Channel amplifiers are equipped with a
bass boost @ 45Hz
The “EUPHORIA ” amplifiers include built-in variable crossovers. The crossover features
a variable frequency selection for precise low pass filtering for all mono amplifiers. The
Multi-channel feature independent 12dB per octave High Pass and Low Pass X-Over
Network.
T265 - 2 Ohm Stereo (2 Channel)
F465 - 2 Ohm Stereo (4 Channel)
F490 - 2 Ohm Stereo (4 Channel)
F4125 - 2 Ohm Stereo (4 Channel)
M350 - 2 Ohm Mono
M500 - 1 Ohm Mono
M1000 - 1 Ohm Mono
M2000 - 1 Ohm Mono
selectable 6dB-12dB
The Mono amplifiers feature a variable 0 - 18db boost set @ 45Hz
Tri - Plex Status Indicator
A Tri-Plex LED status indicator will indicate the operational status of the amplifier.
A blue power LED indicates the power is on and operating normal. To aid in setting up
the amplifier a CLIP LED , will be off during normal operation. When the amplifier is over
driven into a soft clip it will light up orange , this is the normal safe limit of operation of
signal. When the amplifiers signal goes into a dangerous hard clip the Clip LED will turn
red. A red protection LED indicates that the internal protection circuit has been activated.
The protect LED will remain off at all other times
FEATURES AND BENEFITS
Multi-Link
The Euphoria M500, M1000 and M2000 have an internal linking circuit that allows you
to link two like model amplifiers so that you can double your output power to a single load.
When linking two like amplifiers they are split up into master and slave units. The master
amplifier becomes the main control for all input signals and gain controls.
