32
DVA KS10
Code 420120233 REV. 1.0
English
•
Connect the cable (or cables) from MIXER/LINE to the BALANCED AUDIO (1) input
(or inputs) of the first sub. module. For this purpose, use a cable equipped with an
XLR connector (not included). For further information about available cables, see the
picture on p. 29.
•
Extend the signal between the first and the second module. For this purpose,
connect the Balanced Output (or Outputs) (8) to the Balanced Inputs (7) of the
second module.
• Repeat the operation between the second and the third modules, and so on, until
all sub modules are connected, based on how many are needed and up to the
maximum number permitted by the information on the nameplate
CONNECTING AND POTENTIAL LINKING OF AUDIO SIGNAL BETWEEN 2 SUBS
SECOND DVA KS10
FIRST DVA KS10
MIXER/LINEA
SECOND DVA KS10
FIRST DVA KS10
LINK
MIXER/LINE
INGRESSO
MONO CONFIGURATION
LINK
STEREO CONFIGURATION
INGRESSI
FIRST DVA KS10
FIRST DVA KS10
