56
VIO-L210
Cod. 420120248 REV. 1.1
STACKED INSTALLATION (EXAMPLE OF 1 OR 4 MODULES ON SUB318)
•
It is possible to install a maximum of 4 modules in a stacked configuration on the
DRK-210 fly-bar, for safety reason.
• Use the DBTECHNOLOGIES COMPOSER to set the project parameters.
•
Place the DRK-210 fly-bar on SUB 318 (installed on a level with no inclination). For more
information about this accessory, see further details in the full manual.
• Add the VIO-L210 modules one by one, with the previously calculated angulation,
as shown in the
paragraph.
• Verify that the local parameters of different modules are properly set on the individual
amplifier panels. In particular, verify according to the project: Audio Attenuation,
Speaker Coupling and High Frequency Compensation settings. Alternatively, you can
also remotely and in real time change all parameters later, if the line array is connected
via the RDNet network (DBTECHNOLOGIES NETWORK). However, it is good practice to
physically replicate at least the initial settings of the project on the VIO-L210 modules
before the installation. For further information see the section
.
• Perform audio, RDNet and power supply re-launch connections as described in the
previous paragraphs.
WARNING
!
•
If the support surface presents
even the slightest inclination, it is
necessary to properly fasten using
the appropriate mechanical means
and/or installation straps.
Summary of Contents for VIO L210
