12
moving machinery, and sharp edges. Contact Capital Safety if you
have questions about using this equipment where environmental
or physical hazards exist.
COmPaTiblE COmPONENTS:
•
Capital Safety equipment is
designed for use with Capital Safety approved components and
subsystems only. See also General Instructions for Use and Main-
tenance 1.8 and 1.12.
wARNINg: Do not alter or intentionally misuse this equipment.
Consult Capital Safety when using this equipment with components
or subsystems other than described in this manual. Some component
combinations may interfere with safe operation of other equipment
in the system.
COmPaTibiliTy OF CONNECTORS aND makiNg CONNEC-
•
TiONS:
Connectors (hooks, carabiners, D-rings) used to suspend
the Rollgliss
®
Rescue Emergency Descent Device must be capable
of supporting at least 1406 kg (3,100 lbs.) and meet EN362 stan
-
dards. See also General Instructions for Use and Maintenance 5.
aNCHORagE STRENgTH:
•
Anchorages used to suspend the
Emergency Descent Device must sustain static loads, applied along
the axis of the device, of at least 13.77kN (3,100 lbs.). When more
than one Emergency Descent Device is attached to an anchorage
the strengths stated above must be multiplied by the number of
descent devices attached to the anchorage.
wARNINg:
Use of this equipment for an application that does not
meet the preceding anchorage strength requirement(s) may result in
serious injury or death.
3.0 TRAININg
It is the responsibility of the users of this equipment to understand
these instructions, and to be trained in the correct installation, use,
and maintenance of this equipment. These individuals must be aware
of the operating characteristics, application limits and consequences
of improper installation or use of this equipment. This user manual
is not a substitute for a training program. Training must be provided
on a periodic basis to ensure proficiency of the users. See General
Instructions for Use and Maintenance 1.1.
4.0 PlANNINg
bEFORE EaCH USE: of this equipment, carefully inspect it according
to Section 7.0 of this manual.
Your emergency escape system should be thoroughly planned prior to
installation to insure proper location and configuration of the access
and landing areas. Careful consideration should be given to the
following aspects:
aNCHORagE:
•
Select a rigid anchorage point that is capable of
supporting at least 1406 kg (3,100 lbs). See Section 2.0 Anchor
-
Summary of Contents for Rollgliss
